Here's how this started.
I just got the FJ40 running after a nearly 3 year restoration effort.
Hazard and turn signals were working (single flasher on my 79)
I had it sitting in the driveway running and my wife came out to check it out. I swear to god my wife can break any piece of technology she gets within ten feet of. She doesn't even have to touch it -- just get near it. This is based on 40 years of experience.
So she's behind the cruiser and ask if the turn signals work. I reach in confidently and flipped the NEW turn signal lever and no turn signals......
It so happened I purchased a new flasher but didn't install it during the rebuild. I connected the new flasher and both the hazard and turn signals worked.
Just for kicks I decided to reconnect the original flasher, without my wife in the area, and both the hazard and turn signals worked.
Further evidence - I had to pause while writing this to go downstairs to get clothes out of the dryer ( I'm not typing this in my boxers) and my wife asks me if I could screw the cap into the rinse fluid dispenser in the dishwasher. Three little prongs on the cap go into three little slots in the dispenser and a simple 1/4 twist. Took me all of 3 seconds but she couldn't do it...... You should see her with a computer or phone!
Assuming the problem with the turn signals is/was flasher related it would appear that the hazard lights can work while the turn signals don't.
For now I'll just keep an eye on them to see it the problem reoccurs.
PS - my wife is height challenged so its unlikely she'll ever be able to get in the cruiser else I'd end up blowing a engine........