trouble locating the vibration

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 11, 2004
Threads
173
Messages
1,774
Location
tunica, ms
i've had my tires balanced, transmission was rebuilt, new orion transfer case, new rear driveshaft, front end just rebuilt. the tires are 35x12.50 on 15 inch mickey thompson classic locks. the tires in front are about 50% and the rears are a little less. when driving down the road i can see my front fenders wobbling, but it feels more like a vibration than a wobble. any ideas?
 
missipboy said:
15 inch mickey thompson classic locks.

By this statement are you running beadlocks? If so did you try to balance them? Do the vibes come on at a certain speed or they are there from when you start rolling? Also, was your new driveshaft balanced?
 
tires are radials. super swamper ssr's. i guess that's not bias ply, right?

wheels are fake beadlocks. and the vibes come at higher speeds. say, over 35mph. yes, the driveshaft was balanced.

not sure how many bolts, but i know i'm missing at least one or two per side.
the inner support is attached to the frame with three bolts per side. i know there is one rusted off on each side.
 
If you can grab hold of them and shake them standing still....they will move all over the place while going down the road bud....
 
ok, that makes sense for the fender vibration, which makes me feel better, but i still have a vibration while driving and doesn't that wear seals out pretty quick? i got under it yesteray and was pushing on my driveshaft. i can push it up just a hair. is there supposed to be any play in that rear output shaft? it's a brand new transfer case.
 
missipboy said:
yes, it's on right.

I think he means phased properly, where the yokes are aligned both ends. You can get vibration where they are out of phase. Ujoints gone bad are another possibility.
 
Last edited:
missipboy said:
ahhh,
well, i put it the driveshaft on and since i have no idea about phasing it properly, there is a good chance it isn't. i just bolted it on. how do i phase it properly?
the u-joints are good.

The "U"s of the U-joints on either end of the driveshaft must be perfectly aligned parallel to one another.
092a2 (Small).gif
 
Yea, if it's out of phase, just unbolt the short slip yoke end (#5 in above pic), pull it out, reinsert it where it aligns exactly with the other end of the driveshaft. And yeah, it's also best (for you) to have all the zerks lined up to make a lubing simpler.
 
it's lined up, so i don't think that's the problem.

i'm starting to lean towards my tires. i think most of the other things i have checked. i did find some dirt packed into my rotors. not in the center, but inside the slots between the braking surfaces.
 
Back
Top Bottom