Trouble Installing Pertronix on F engine

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 24, 2016
Threads
4
Messages
14
Location
Grand Rapids, Mi
I was trying to install the unit today, 1665A, and used the Offroad.com install as a guide. When I tried to fit the base plate in, it did not fit. I have a slotted head that rotates left and right, and I have no idea what it does. Also my dist looks opposite of the one on Offroad.com.

dist1.5.webp


dist1.webp


dist2.webp
 
The distributor shown is not yours, right? It's not a Toyota distributor.
 
That is an early 50's Chevrolet 6 cyl. distributor. If I remember correctly it just required the removal of the Chevy drive gear and replacement with your Toyota drive gear. You'll need to exchange your kit for the Chevy counterpart.
 
The second picture is mine and the third is the close up of the screw.
Thank you Byron for letting me know what it is. You guys rock.
It sounds like my best bet would be to replace it and go with a Trollhole distributor. That should give me the correct one plus no need of the Pertronix unit.
 
The screw you are asking about is for adjusting the points gap. The center of the head is not the same as the center of the screw body, offset centers. If you look at the pic you will see that the head has left marks showing on the backing plate that show this off center action for the head. There is an elongated (oval shaped) slot in the points back plate that sets over/around this screw head. As the screw head is rotated the points back plate is moved left or right, which then adjusts the points opening.

Other brands of distributor use different methods for adjusting the points. One method uses opposing slots on two different, parallel plates. A flat tip screwdriver is set into this opening and twisted to move the two plates in opposite directions to adjust the points gap.

Don
 
Back
Top Bottom