Transmission questions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 21, 2004
Threads
73
Messages
597
Location
The Rockies or the Andes
Is any wobble in the input shaft acceptable in a 4 speed tranny? I can move it about an 1/8" from side to side.

Also, how much wear is acceptable on the output shaft? I have about an 1 1/2" of the shaft worn down about 1/16" on one side of all the splines.
 
The input shaft wobble is normal. Spin it and listen/feel for grinding. Remember the end of the input shaft you can grab is supported by the pilot bearing in the end of the crank.

Can't answer you on the output side though. A picture of the wear might help others.

Nick
 
IanB said:
Also, how much wear is acceptable on the output shaft? I have about an 1 1/2" of the shaft worn down about 1/16" on one side of all the splines.

That sounds like a lot of wear: almost half way through the splines. I would look around for a better one. H42 4 speeds are cheap.
 
Back
Top Bottom