Transmission install question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 1, 2005
Threads
2
Messages
153
Location
Destin, Fl
Ok, I am swapping a 74 4-speed for a 78 4-speed. I can get the transmission to about 1 1/2 inches to mating up. I have made some studs to put in to line up the trans and bell housing, but am still a bit off of that. I have the trans in gear so I can rotate the shaft to align the splines but am still hitting something. I am very close and just getting frustrated at it not working. I don’t want to force it, for it should just slide in. Any tips/tricks/suggestions/miracles?
74 1F stock engine, that had 4 speed before.
Thanks ahead of time.
 
sounds like the piliot bearing..
 
Mace said:
sounds like the piliot bearing..

X2

Have someone step on the clutch while you wigggle it and it will slide in. Might also need to try rotating the parking brake drum with the tranny and transfer in gear to get the splines in the input shaft and clutch disk engaged. If everything else fails, put a little KY jelly on it.
 
mmm KY, I have that.

Thanks guys, going to try some more.
 
Did you change out the pilot bearing when you changed the tranny?


If so, did you fit the bearing to the end of the input shaft before installing it in the crank?
 
I just did not have it aligned exactly. It is in now and thanks for the quick replys. working great, I'm a happy cruiser owner again.
 
i had this issue... i was using longer bolts to guide it in... and in a moment of stupidity started the car to charge the battery so i could run the cd player... forgot that i now had a trans half in and didn't bother with the clutch. something caught... and the tranny seated itself perfectly


not the reccomended way... but it was alot faster than what i was plannin
 
bad_religion_au said:
i had this issue... i was using longer bolts to guide it in... and in a moment of stupidity started the car to charge the battery so i could run the cd player... forgot that i now had a trans half in and didn't bother with the clutch. something caught... and the tranny seated itself perfectly


not the reccomended way... but it was alot faster than what i was plannin
Crikey! :idea:
 
bad_religion_au said:
i had this issue... i was using longer bolts to guide it in... and in a moment of stupidity started the car to charge the battery so i could run the cd player... forgot that i now had a trans half in and didn't bother with the clutch. something caught... and the tranny seated itself perfectly


not the reccomended way... but it was alot faster than what i was plannin


Oh my god!!! That was a bit of luck.....!!!
 
Back
Top Bottom