Transfer tranny combos h42?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

which gear do I count???? pic

are you saying there is a stamp on the outside of the case?


if your casing is the same I would like to buy it....

pm that address again, i will get a check out

mel
 
Last edited:
The drive gear is the one that slips on the trans output shaft....that 'drives' the cluster or counter gear set in the middle of the case...


count the teeth, and post up the part number that you come up with....it should be stamped into the gear... example 90311-38005 this is a seal number, but the 5 dash 5 sequence will be the same...


Good luck!


-Steve
 
Hello,

so I will need to take the case apart.....


currently it is partialy disassembled front cone off

so I don't think I will able to see the gear until I get in a lil deeper



correct?


are the cases the same regardless?
 
The three speed transfer has 29 teeth on the transmission output gear. The four speed has 31 teeth I think. If you're counting 39 teeth you're either bad at counting or you're counting the wrong gear!
 
Back
Top Bottom