transfer case

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 11, 2010
Threads
159
Messages
644
Location
Iowa City IA area
Has anyone ever had to replace the piece that comes out of the transfer case that your rear driveshaft hooks up to? Bought this 96 LC and have some vibration noise under it. Took the front drive shaft off took it in and had the u joints repalced and rebalanced. Went to take the rear drive shaft off to do the same and who ever owned it before me had all the nuts cross threaded on the front side of the rear drive shaft. I still dont have one off the nuts off. The bolt spins. I am going to have to use a saws all to get it off. Any ways has anyone replaced that plate? Is it a dealer item?
 
IIRC the studs are pressed into the rear output flange. You could probably just replace the studs, but you'll need to remove the rear output housing of the transfer case to get it out. Not that big a deal and it can be done without dropping the case. Might as well replace the bearings and seal while it's apart.
 
So I pulled the back housing off today. Pretty easy. One question- 2 metal rings came out as I was separating the back housing from the rest. I see where they go but am unsure how they are held in place. Anyone tell me how. By the way I called the Toyota dealership to see how much they charge for taking off the back housing. They told me it took 6 hours at 100 bucks an hour. It took me a little over an hour and I have never done it before.
 
Back
Top Bottom