Transfer case seepage

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 8, 2007
Threads
30
Messages
148
Location
Nairobi
Website
www.bushwings.org
I recently converted to part time 4wd. The conversion went smoothly and I'm pleased with the results. Got an extra 1 km/liter out of the car on the long trip I did shortly after. However, that's not really what this thread is about. :)

The back of the transfer case now shows some seepage, particularly around the speedo cable attachment. I was careful to follow the FSM and conversion directions as I reassembled, so I'm wondering if this is a typical point for seepage, I missed something, or what. I was careful to clean the surfaces of the transfer case covers, and sealed them back with FIPG as the manual says, during reasasembly..no leaks around those surfaces that I can tell.

Thanks!
Jay
 
There's a spring loaded rubber speedo shaft seal that sits inside housing where the speed sensor screws in can go bad and that you need a small pick to pry it out.
 
Last edited:
^ x2, 2 mintue fix, $1.47 in parts. I just replaced mine yesterday, nice and snug and no more leaking..... at least from there lol.
 
Back
Top Bottom