Transfer Case removal?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Yes, it's pretty simple.

  • Disconnect all the electrical plugs, there are about 6 so make sure you get them all.
  • Disconnect the ground cable that runs from rear of case to body
  • Disconnect the shifter linkage...there is a pin holding the rod ti the case.
  • Remove all the bolts holding the xfer case to trans, there about about 7 or so of them, and they run in both directions.
  • Get a trans jack under the xfer case to support it, and then wiggle it free.
You can do it without a trans jack, but be carefull, it's heavier than it looks.
 
Back
Top Bottom