Transfer Case Problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 18, 2005
Threads
95
Messages
901
Location
SO.WEST,COLORADO
Well, it's 3 days until i leave for Moab, and thought i would check out my 40 for the 10th time to make sure it's ready. So i take it for a little spin, put it in 4 low, all is good. Put it in 4 hi, and WTF. It sounds sort of like a grinding noise, but not really like metal to metal sounds. No popping or binding like gears are trashed. It seems if it were a bearing, it would also affect low range. The seal is dry and drive shaft is'nt sloppy, and is in phase. Heeeelp. Any insight would be greatly appreciated. Mike
 
No insight here.

Sounds peculiar.

Put all 4 wheels on jack stands and run it so you can localize the noise better.

Stay out from under it and have someone in the cab in case something unforseen happens.

If I had to guess, I would say it is a linkage noise issue.
 
Only in 4hi....hmm, the high gear has a big bushing that may have picked up some grit........the shift into hi isn't quite fully engaged or the shift collar is hanging onto the nuetral splines - both caused by a worn hi-lo shift fork/shift collar (max 1.0 mm distance between shift fork arms and collar 'wall'.

Just guessing.

I'd probably try taking loose the linkage from the high-low shifter lever and try putting it into 4 high manually to see if somewhere along that ball's path a place of silence exists. If there is one, adjust the linkage - replace the shift rod bushing -tighten up the shift ball detent spring. If you get it to quiet down go on to Moab knowing that some parts are maybe at their wear limit.

Good luck!
 
Check the linkage isn't hitting the doghouse. Pull the shift boot off and check it out, especially if you have body lift. It could be stopping it from fully engaging. If all else fails, I might be packing a spare down with me :D
 
Back
Top Bottom