Tracing Down a Short (headlight circuit)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 28, 2003
Threads
311
Messages
3,962
Location
Crawlorado.com
Website
www.crawlorado.com
Ive got a Short somewhere in the Headlights

Fuse Blows Right away.. I Put a Cicuit Breaker in place of the fuse, and found the wires hot where the harness conects to the plug going out to the steering column..

Its on the Low Beam Wire heading into the dash either to the right or left side fenders.. any ideas, other than having to unwrap the whole wire bunch??

Ive Heard a Compass will Switch directions when the you pass over the short :confused:


Anywhere i may need to look?
headlight wiring.webp
 
Since it blows right away before you turn the headlight switch on, then the short is before the switched side of the circuit. This would be the red wire that goes from the fuse block to the headlight switch.

If it blows only after you turn the switch on then it could be the red/white stripe wire between the switch and the hi/lo switch, the hi/lo switch itself or on the wires from the hi/lo to the lamps. Before you go unwrapping the harness, check the switches and places where the wires and harness cross any chassis metal.
 
Thanks, maybe i needed to be more clear..

It Blows when i put on the Low Beams.. High Beams are fine, switched off, or on just running lights Fine too..

I unpluged the harness from the Colum and made a bypass wire at the connector.. still blows, so im guessing its in the Red/Green wire heading into the harness and into either the right or left Fender toward the lights..

Just wondering it anyone had any other thoughts..
 
If you disconnect the plug and it still blows, it indicates that the short is in the circuit before the disconnected plug, not downstream from it. I can't tell from the picture which connector you are referring to since there are two shown and I can't tell the color code of the wires. Since it only blows on low beam, I would suspect the switch or the wire from the switch to the plug. The switch is more likely since it is a moving aprt more subject to wear. It is not likely to be the wire to the lamp, unless you are unplugging an irrelevant connector.
 
Back
Top Bottom