I pulled my boat for the 1st time this afternoon with the LX. I have only towed it with an F250 Diesel, so I was a little nervous about the 25 mile trip. However, I needed to get it out of the water and into dry storage for the winter and my buddy's F250 was not avaialble. These rigs are rated for 5000lbs here in the states so my load was a little over that rating.... right around 7900lbs. My boat trailer has 4 wheel disk brakes which are the surge type, no brake controller needed.
I had a couple of long grades (7-9%) which I had to crawl up but other than that it did great. I would reccomend stabilizer bars for loads of this weight if you are going to travel great distances at HWY speeds. The water temp stayed right around 189-192 for most of the trip, according tot he Scanguage. I have been kicking around the idea of upgrading springs to 850Js and some 863s. I think the 863s will help the cruiser sit a little more level when I pull the boat.
I had a couple of long grades (7-9%) which I had to crawl up but other than that it did great. I would reccomend stabilizer bars for loads of this weight if you are going to travel great distances at HWY speeds. The water temp stayed right around 189-192 for most of the trip, according tot he Scanguage. I have been kicking around the idea of upgrading springs to 850Js and some 863s. I think the 863s will help the cruiser sit a little more level when I pull the boat.
nice cruiser and boat 
