towing question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Thanks Texx. I'm very seriously considering the dolly. I'm well aware of the limitations with speed, turning, brakiing, backing etc. Like I said I'm not taking this lightly, I'm just lookinig for ideas. I just need to get her to the campground and she'll be the daily driver after that. I have made this trip several times and always try to take the best roads with the least construction. I don't like towing any trailer over 60 and most certainly wouldnt pull this rig any faster. Of course I'll try it around town and on the hightway before I pack up and take off on vacation. Thanks again.
 
jaybonecrow said:
I have several post on IH8MUD where both my wife and I have flat towed several FJ40 from TEXAS to NM, CO, OK and KS over the past 20 years. Its just like pulling a trailer.
Sure a few of you may have had a bad experance flat towing but it could also happen with a trailer. We have used everything from a 3/4 ton truck to a 2005 GMC Canyon to pull our 40's. I don't care what anyone says. DO NOT TIE THE STEERING WHEEL. Not even with a bungee cord. The front needs to turn as you turn...just like a hay wagon or your kids little red wagon. Tire size really doesn't matter either. We have 35 M/T's down to 30 x 9.50 A/T's the all pull about the same.

Ditto, I have flat towed my cruiser before with no problems. Other than not turning in a tight radius, you should be fine. If you are going long distance I would remove the rear driveline just to be safe. I have heard it is possible to fry your t-case when flat towing. Cant figure out how this is possible, but why take the risk.
 
Texx said:
Using a tow dolly takes all the drama out of towing a 40. I have both, along with a trailer, and have flat towed, dollied, and trailered 40's, 60's, etc. all over the southwest. I'd go trailer number one, dolly number two, flat tow last option. There's no problem flat towing if you realize the limitations. A half ton pickup when flat towing will be a big problem in less than optimal traction conditions...the weight of the cruiser will push the rear of the truck out on turns, especially tight ones. Additionally, steep downhills can be a white knuckle ride. Tow dolly eliminates all this. A friend of mine tows his 40 behind his travel trailer, but it's a fifth wheel, I wouldn't even consider it with a bumper pull trailer, fifth wheels are much more stable. He limits speed to around 60. I have towed my gooseneck coast to coast with two 40's, or a 40 and a 60, no problems, but you're limited by braking, and the dot is getting to be real bad in Tx. You can flat or tandem tow legally in TX or NM. You are limited by overall length in both states. Side note...I have about 5 tow bars lying about if anyone wants one cheap and doesn't mind paying shipping.

I tow mine with a 1997 1/2 ton full size GMC and have had no problems at all. Obviously you need to pay attention and adjust your speed accordingly to downhill grades. I would not do it with a bumper mount, only a true reciever hitch.
 
flat-towing a 40 with a 1 ton dually behind a travel trailer shouldn't be a problem. You didn't say how long the travel trailer is, but if it's anything bigger than a pop-up it should have enough mass to keep the 40 tracking straight. You won't be able to backup without jackknifing, but if you plan your stops this isn't an issue.

Your truck is more than capable of handling this setup.
dodge_power.webp
 
I definitely haven't seen everything on the road, but I've never seen a recreational triple tow with the last vehicle being towed weighing 4,000lbs on two axles at least 90 inches apart with the front having steering. Sounds spooky to hear it, but I've never even seen it, so I couldn't say it shouldn't be done by a prudent driver that keeps the speed down. I've mostly seen triple tows with a pickup/SUV towing a travel trailer with a trailered, light boat hooked to the rec trailer. Folks that want to fish from a boat while having a travel trailer camp and the pickup/SUV for transportation.

It can be dangerous, but as others mentioned, speed is arguably a greater concern. Case in Point:
A couple Summers ago along the Rocky Mtn Front in Montana, a late '90s Dodge CTD extended cab towing an ~24 ft travel trailer with a trailered small fishing boat hooked last passed at highway speed another rig on a two lane highway and promptly began to fishtail wildly, lost control, and rolled. Killed the driver, his wife, and put his mother in the hospital for months. The cab was crushed to the doors and had basically no room to live. No one knows how the elderly mom even survived.

Be careful out there. :)
 
Jaybonecrow, you said NOT TO TIE THE STEERING WHEEL. Why is this? My one and only flat tow experience I had to lash the wheel to get where I was going because every time I took a corner the cruiser wheels refused to return to center and I was dragging the tires sideways until I stopped. Is that a caster problem? Admittedly it was before I rebuilt the knuckles.

Thanks. . .
 
morrison said:
Jaybonecrow, you said NOT TO TIE THE STEERING WHEEL. Why is this? My one and only flat tow experience I had to lash the wheel to get where I was going because every time I took a corner the cruiser wheels refused to return to center and I was dragging the tires sideways until I stopped. Is that a caster problem? Admittedly it was before I rebuilt the knuckles.

Thanks. . .


Based on my experience flat towing, I'd say it was some sort of allignment problem. I've towed pickups of all sizes both 2 and 4 wheel drive without tying the steering wheel and the 1 time there was ever a problem was when taking a VERY short turn the tires of the towed vehicle did not return to center.
 
MOfj40 said:
flat-towing a 40 with a 1 ton dually behind a travel trailer shouldn't be a problem. You didn't say how long the travel trailer is, but if it's anything bigger than a pop-up it should have enough mass to keep the 40 tracking straight. You won't be able to backup without jackknifing, but if you plan your stops this isn't an issue.

Your truck is more than capable of handling this setup.

My travel trailer is a 29' bumper pull with weight distributing and anti sway bars all in use as well as good brakes and controller.
 
Rocknroll said:
My travel trailer is a 29' bumper pull with weight distributing and anti sway bars all in use as well as good brakes and controller.



I would make sure this is legal, as I know that it is not around here(MN)....first trailer must be on fifth wheel/goose neck set up, and NOT on the bumper...and last item in train cannot be over 2500#'s....



In all honesty, I think that you are asking for trouble....but to each their own.


Good luck!


-Steve
 
The reason your 40 would not return to center is because it doesn't have enought caster. They only have 1degree from the factory and lifts, worn parts, aftermarket shackels or anything that is not stock or up to snuff can send your front end into to negitive caster. This is great for no power steering rigs because it makes it easier to steer but caster is what also makes it return to center. Rebuilding the knuckles will not change caster. If everything is good (bushings, shackles etc.) Then what i have done is add a shim between the spring pack and the axle. Pointing the pinion down gives more caster. I had the same problem after I lifted mine and added a 2.5 degree shim and it now flat tows fine. Tying the steering wheel is masking a problem that may show up a highway speeds, that is why it is dangerous. Good luck. Tom
 
Thanks Tom! I've been thinking for awhile I needed to go the shim route--now I'm sure of it. I'll be replacing stock springs and add-a-leafs soon with 4" Skyjacker springs. Will 2.5 degrees be enough?
 
Back
Top Bottom