Tire size

[Shralp17]

Can you run 32/11.5/15 on a stock landcruiser original rims and lift? Eventually I would like to lift my cruiser and put on 33's. So I don't know if I should just wait and do it all at once lift and new tires. Will 33's/10.5/15 fit on stock rims? I did look in the FAQ section on what tires people were running but most of the vehicles were already lifted.

 

[Heckraiser]

Yes and yes. I would wait, personally, and do 33's, lift and 4.11 gears at the same time.

 

[klinetime574]

31's on a stock 60 is a proven fact here on MUD, gives you a little OD on the highway and a little more tire to play with.

Then the step to 33's, I would advise so 8 inch wide or 10 inch wide wheels.

Someone would buy your used 31's because like I said people like them!

Hope that helps!

 

[Shralp17]

Thanks for the advice. I will get 31/10.5/15 tires right now. I need to get tire before the lift. The tires I purchased with the vehicle are quite old and right now I am running studs.

 

[Kynot62]

33 10.50's fit on stock rims just fine by the way. General rule from tire makers is to not run a rim that is more than 4 inches narrower than the section width. But 10.50's are only a touch wider than this. Running them on stock rims will also make them a little taller compared to a wider rim.

While a little tight on a stock springs, a set of add a leafs (about an inch and a half of lift) are not that much money and can get you by while you save up for the full lift kit.

There are options other than gears by the way. And realistically The stock gears with 33's work just fine with the H42 in a stock 60. The auto in a 62 is another story. Try this link for some more info The Wagon Way

Tony