Time to replace starter??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 4, 2006
Threads
636
Messages
23,860
Location
Buckley, WA
I went to go and start my rig for the first time in a few months yesterday and.... nothing. :mad:
After checking fuses I decided it was the starter and hit it with a small hammer a few times. Started after that.
So was this just a one time thing from sitting for a while or do you guys think the brushes or the entire thing might be ready for a redo??
 
to be safe it should be rebuilt just so you dont end up stuck some where in the woods. if you see dirt/mud alot it could just be packed full and need to be cleaned out. they arent that hard to take apart if you know what you are doing and you can normally get away with just taking fine sand paper to everything and putting it back in rather than spending alot of money.
 
mine did the same thing. things only degraded from there, this is what I ended up with:

100_0768.jpg
 
Yeah I think when I get a chance I might take mine apart and have a look.
 
Anyone know what the brushes or the entire starter would run? I don't want to have to call Dan and bug him if i'm not ready to buy yet.
 
Back
Top Bottom