Tie Rod End Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 8, 2017
Threads
38
Messages
347
Location
Portland Maine
Website
www.dogwashetc.com
I am replacing the tie rod ends on my cruiser. This is the tie rod on the back side of the front axle (inner tie rod?). I had a bitch of a time getting it off but was successful with a 14" pipe wrench and a two foot pipe on the end of that for leverage. It was still tough going even with that extra leverage. Mind you this tie rod and end has no rust at all, so I was surprised with the level of effort that went into it. Anyway I have a new tie rod that I'm trying to screw back in but I cant thread it in. I've tried both clockwise and reverse thread but still nothing. So now I'm not sure which way to screw it in. Im starting to think the tie rod end is slightly deformed creating a problem. So can someone tell me if the tie rod has reverse threads on one side, or maybe both sides, or am I just mechanically challenged!?
 
Yes, left hand thread at one end, normal at the other.
In the past, I've used a zip disc to grind a sharp v out along the length of the old tie rod ends to create a clean out tap, use it to chase out the thread in the tie rod before fitting new ones.
They can be an absolute ball bag to change
 
There may be a problem with the threads inside the rod. I say this because you had so much trouble removing the old rod end that was not rusty. Or, your new end is not the correct diameter at the threads.
 
The rod ends for the front link are different diameter than the threads for the rod ends in the rear link.
 
Yes, left hand thread at one end, normal at the other.
In the past, I've used a zip disc to grind a sharp v out along the length of the old tie rod ends to create a clean out tap, use it to chase out the thread in the tie rod before fitting new ones.
They can be an absolute ball bag to change
Good tip. Thank you.
 
The tie rod ends are larger than the drag link ends so I don’t think that’s the issue
 
Back
Top Bottom