Three day wood!

[cruiserdan]

If he were to fall out would that be considered "cottus-interruptus"?

 

[semlin]

not if he still had the three day wood

 

[PHAEDRUS]

The thing to remember with all vehicles is that they are built to a tolerance.
IE the rear cross mill should measure X + or - .05 mils.
this goes for every body and suspension mount point on the vehicle. Hell just last week I looked at a lx470 that took a straight on rear end shot.
the right side frame rail was shifted left to the outside of tolerance and the rt side rail was dead square. This truck had 800 miles on it.
Not that this is of any help to you Todd.
Dave

 

[Kaderabek]

Yes, sell them to me and buy the step slider that you really want.

Wish I could!

Taking the day off, about to crawl under there and address the problem.

Will report back.

TJK

 

[Kaderabek]

Done. Fixed. Bottom line: it's a surprising amount of grinding.

Thanks guys.

TJK

 

[elmariachi]

Done. Fixed. Bottom line: it's a surprising amount of grinding.Thanks guys.TJK

You were wearing me out with this thread. I was thinking I was going to have to come get my damn truck back.

 

[Kaderabek]

Bring brisket.

TJK

 

[sleeoffroad]

Done. Fixed. Bottom line: it's a surprising amount of grinding.

Thanks guys.

TJK

What did you grind? The crossmember. You can also loosen the bolts and move it sideways, but that is more work.

 

[Kaderabek]

Loosen them? I took the whole thing off. In record time!

Yeah, ground down both the front and back sections of the crossmember where they go under the cat.

TJK