the death wobble

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 9, 2007
Threads
63
Messages
245
Location
FLagstaff Az. Elv.7000ft
Wellp got around to correcting my caster today and now i got the deth wobble....35 to 45 mphs ...what the hell??????
Had a slight shimmy before but now its out of controle!!!!!!!!
Any ideas??
 
Sorry maybe i should tell u that it drove very well before the correction........with only a very slight shimmy @ 35mphs but would go away as fast as it came.
 
My first test is "check your nuts"!:hillbilly: Most often this is caused by a loose panhard bolt, but arm bolts, knuckle nuts, etc can do it. I set the torque wrench 130, check the all of arm and panhard bolts, then 75 for the knuckle nuts.
 
Well, you corrected part of your alignment, but not all of it. Make sure toe is good, and yes, check your nutz :flipoff2:
 
I had a wobble and it was from some slop in the steering box. Basically something is loose down under, bearings, bushings, bolts nuts, the list goes on. You just need to dig in there and find it and that can be the big challenge.

BTW, how did you correct the caster? If you had bushings installed maybe they weren't pressed in correctly or didn't provide enough correction.

If you can't find anything loose then a trip to the alignment shop would be a good idea.
 
after lookin found bad bushings in the radios arm!
still got a shimmy at the 45 mphs but the death wabble is gone.
Old BFGs r the problem....
Thanks for the iinfo.


Rob
 
Back
Top Bottom