The amazing twisting wheel

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 11, 2004
Threads
150
Messages
1,043
Location
high desert, ca
A few weeks ago I headed out to the oceano dunes and was a little rough on the cruiser. The five or six hours home on the freeway were fine. But, when driving straight, my steering wheel was completely upside down. When I left, it was in the normal position, not with the toyota emblem upside down. I thought I bent a tie rod and ignored it for the last few very busy weeks. Upon further inspection, nothing is bent or loose. Any suggestions? It still drives the same as it did before, swerving above 70mph and all. Can the steering shaft twist on the input splines of the steering box?
Thanks
 
any chance the center/horn just got turned around? on my early 40's it just spins around....................
 
On the 9/72-40 series and on, there are three screws that hold the center cap to the steering wheel, so unless there is an early steering wheel in this truck for some reason, I would rule that one out.


I would look at everything again. I would bet that something is bent...



Good luck!


-Steve
 
sometimes the steering column can twist so i've been told.

is the front end any lower than it used to be (i.e. sagged?)
 
I twisted the sector shaft in a K10 Chev steering box once (not that bad of course), look at everything closely, you don't want a fatigued part failing on your way down the road.
 
I've heard the 80 series guys have this problem after wheeling hard. They'll come off a hard trail and have the wheel 90 degrees out and nothing seems bent. The splines must slip somewhere. Its never happened to me on any of my rigs so I won't hazzard a guess where the things get loose.
 
Front end still seems the same height. The entire steering wheel, not just the emblem got twisted 180 degrees. My concern is having something break while driving. Oh yeah, its an early 1969 fj55 that came from the factory with the later style center control, also running a mini truck tie rod, arms, etc. Every tie rod end seems tight. Seems like it would take a lot of bending to move the wheel that much.
 
The steering wheel itself has splines, doesn't it. Could be slipping on the shaft with just enough nut tension and worn splines to keep it from spinning under normal use. Easy to check.
 
I've had this happen a number of times after hard wheeling. Usually occurs when I've had the wheel cranked to one side and the tires wedged against a rock. For the longest time I could not find the source. Nothing was bent, broken or loose. I finally figured it out by placing alignment marks on all of the splined joints on the steering shaft - from the wheel to the saginaw box. It was jumping splines not at the steering wheel but at the input to the steering box and slightly at the output near the firewall. I have a splined connector at the saginaw box that is slotted and held with a clamp. This where most of the slip was occuring even though the clamp was tight.
Recenter your steering wheel, mark the alignment of the splined joints in the shaft, tighten all of the retaining nuts and wheel it hard again. Then check to see if anything is off.
There is a tremendous amount of pressure on these connections; especially when running large tires, a large steering wheel and power steering. It doesn't surprise me that this pressure can cause the outer splines to expand enough to jump.
 
I would look REALLY CLOSE at the steering center arm.
 
You'd be surprised how little it takes to flip a steering wheel 180 degrees from where it was, whether it's because of bending, jumped splines, or adjustment.

I'd take this seriously and agree with shipwreck and Mark about the forces at work and the center arm. Something's wrong and it might break next time.
 
Back
Top Bottom