Temp guage not working! Help!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 20, 2003
Threads
36
Messages
104
Hi all,
Need some help getting my temperature guage to work on my BJ40. Im pretty sure the sender is fine as i replaced it recently ; and the guage works because i took the instrument cluster off and tested it. Can anyone explain how the wiring works to me? What wire sends the signal to the guage? Im really stuck i cant work out why its not working.

If i connect a multimeter to the back of the guage, both sides of the guage appear to have 12 volts. Thanks

Ryan
 
It works like any other electric gauge. The meter gets power from the fuse block. Then a wire from the other side of the gauge goes to the sender, which is a yellow wire for the temp gauge. The sender is a temp dependent variable resistor. When cold, the resistance is high, so the current is low and the meter reads to the left. As it warms up, the resistance drops and the meter reads higher. The sender body is grounded in the engine block. You didn't wrap the sender in teflon tape, did you?

BTW, I thought BJs were 24 V.
 
nah in australia they are 12 V, must be different for you guys...
 
which is the sender wire? which colour? and what voltage should be coming out of it? anyone?
 
a yellow wire with a black strip? mine has no voltage :( what could be the problem?
 
RyRy said:
a yellow wire with a black strip? mine has no voltage :( what could be the problem?

how about this, get another piece of wire to bridge the connection between the sender and the gauge.
I bet the problem lies in the connectors themselves. see if you have continuity. I'm sure you have a wire diag. don't just follow color codes, they may have changed since the prev. owner ...
 
The color code for N. American model BJ40s is Yellow with green stripe for the temp gauge. If there is no voltage at the sender, check for voltage at the gauge. If there is a voltage at the gauge, then the wire to the sender is bad. If no voltage at the gauge, then check the fuse and the wire from the gauge to the fuse block.
 
is there a way to test if the sender is working, with a multimeter?
 
My temp meter doesn't work on a 74 F engine but if I ground the wire at the engine the temp meter goes to high so I'm thinking it's the sender. There's a fuse for the gauge cluster. On the gas FJ it's the only 5 amp in the box. If it's blown the fuel gauge and oil pressure gauge(at least on my 74 FJ) wouldn't work either.


Kevin
 
RyRy said:
is there a way to test if the sender is working, with a multimeter?

Use an ohm meter on the sender; one lead to the center post, the other to the metal case ground. The resistance should drop as the temperature increases. If there is no voltage at the sender, this is a problem, so fix it first. Sometimes you have to just dig in and get under the dash. Don't worry abut the wires. Just look for the one with the right color code.


Toyo FJ40 said:
My temp meter doesn't work on a 74 F engine but if I ground the wire at the engine the temp meter goes to high so I'm thinking it's the sender.

Good guess.
 
Back
Top Bottom