TECH Question - HELP

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 30, 2007
Threads
13
Messages
26
Location
Western Mass
Looking for some help / advice. Have a 77 FJ40 and recently noticed some wobbling coming from the lower pulleys below the radiator. Was wondering if I need to tighten this, or maybe some ball bearings? I'm about to slap on some brand new belts so I'll have a better look at this. Any advice would be awesome! Thanks in advance.

:steer:
 
Looking for some help / advice. Have a 77 FJ40 and recently noticed some wobbling coming from the lower pulleys below the radiator. Was wondering if I need to tighten this, or maybe some ball bearings? I'm about to slap on some brand new belts so I'll have a better look at this. Any advice would be awesome! Thanks in advance.

:steer:

Yeah, the big lowest dual pulley is your crankshaft pulley, prolly not a good thing to have wobbling around

034D1.gif

Take off the belts and see if there is any play in the pulley, check the bolt, threads, and keys, and tighten that baby up as long as all the nutz and boltz are good
034D1.gif
 
Last edited:
Stop driving it until you get this fixed!

First make sure item #13 is there, if it is remove it and item #14 and #15 and listen for item #16 to hit the ground. Inspect the end of the crank for damage. Specifically the key way where item #16 sits. If thats all good then inspect the crank pulley (harmonic balancer to some) for damage. If you are very lucky everything will be good and you can reassemble. Torque item #13 to, what is it? 120-130 ft lbs? Can't remember. Then bend the tabs back over the nut to lock it in place...
 
Back
Top Bottom