Tappin' the starter...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 10, 2005
Threads
360
Messages
4,040
Location
КАГІҒОЯИІА
I think my starter needs to be rebuilt but I just want to verify before I start tearing it apart because it has only been about 40K since it was replaced.

Sometimes, I turn the key and nothing for the first couple of turns then it starts.

After a warm run, sometimes I shut the car off and when I go to start it up again, nothing at all until I tap on the starter with a tool while someone is turning the key.

I am fully aware of the tight contact issues but the tapping thing bothers me.

Is it just the contacts, brushes, what?

I forgot to add that I am not really in a corrosive area, one that would gunk up the starter.
 
My mini has a aftermarket rebuilt starter, I pressure washed the motor and a week or so later it wouldn't start. Took the starter apart and they left all of the rubber seals, breather, etc out! The plunger was rusted and sticking, cleaned it up and it's working, but I am keeping an eye out for an unmolested one to replace it.
 
Should also check your ignition switch and the wire that runs from the switch to the solenoid. My 4runner had that problem, and the resistance on that wire was nearly infinity. PO had put 4 starters in it in 6 months. I bypassed it with a pushbutton and a dedicated new wire lead(who knew i was a trendsetter 20 years ago with that...it seems to be the rage on new cars these days...).

The ignition switch can become gunked up just like the window switches.

You can also make sure your vents and rubber caps arent letting water and crap into the starter.
 
Back
Top Bottom