tailgate stove

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Pretty sure he mentioned in the old thread that it was a really expensive Meile but he picked it up for a really good price
 
I had an idea similar to this. It was to be able to use the tailgate as a storage place. I was gonna have the license plate portion plasma cut out and flip it around, or weld a panel to make it flush, then make a place big enough for your hand to still get to the latch. Then plasma cut the "lid" off, from the inside, and bolt a hing on it and put a weather seal along the rim as a silencer. This would make the tailgate a sorta "suitcase". You could line it with a short pile carpet and use it for carrying anything from recovery gear to cloths for a trip.
 
Any concerns about compromising the strength of the tail gate? CDan covered his with aluminum and in that thread others complained that their gates had creased or buckled due to weight or whatever they were subjected to. It seems that turning it in to a suitcase, or otherwise removing the existing strength provided by the front panel would increase this problem. Not a high incidence, don't everyone go out and start reinforcing your gates, but it seems this would create a problem that otherwise wouldn't be an issue.
 
The weak-spot in a gate that is not cut up is the lower middle section, in between the hinges. The 91-mid 95 are the worst. In mid 95 the gate was changed and has some additional support.

I DO NOT recommend anyone stand on an unreinforced gate or kneel directly on the lower center in between the hinges. The upper edge and the sides are much stronger.

OTOH, toss a 1/4 inch sheet of 6061 on it and you are good-to-go.....;)
 
CDan - Any easy way to identify the difference for those off us with a 95? Or do you know off a cut off date between the tailgates?
 
CDan - Any easy way to identify the difference for those off us with a 95? Or do you know off a cut off date between the tailgates?

I believe (and i could be wrong) if you take the access panels off and either look in side or reach in as far as you can towards the middle of the tail gate you should feel a small "I beam" of metal supporting the tailgate. Im sure Cdan can chime in here.
 
The weak-spot in a gate that is not cut up is the... The upper edge and the sides are much stronger.

OTOH, toss a 1/4 inch sheet of 6061 on it and you are good-to-go.....;)

Dan could be a politician. No offense Dan. ;) Note that he said the weak spot in a gate that is NOT cut up. No telling what new weak spots are being created by some of these proposed mods until you do some field testing I suppose.
 
Dan could be a politician. No offense Dan. ;) Note that he said the weak spot in a gate that is NOT cut up. No telling what new weak spots are being created by some of these proposed mods until you do some field testing I suppose.

Im more then confident my design will work fine. as for more strength there will be layer of aluminum over the stove when closed meaning all strength that might have been lost will be more then regained. :D
 
Yours is very cool. I look forward to getting the field report after it's done. I'm sure it will work great. You've taken a lot of things in to consideration.
 
Back
Top Bottom