Swaybar Quick Disconnects

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 1, 2006
Threads
126
Messages
859
Anyone make some of these? After wheeling with my jeep friends a few times and seeing how much more flex you get without them id be interested in some.
 
do a search for... i think.... landcruiserphil. He has some pretty sweet custom frame mounts to keep the disconnected swaybar up and out of the way.
 
Ouback Offroad is working on some pneumatic ones.

Last I heard he had the prototype on his rig and was giving them the real world test.
 
I've been doing the hitch-pin thing with them for a while--it seems to be working fine so far.

Welded u-shaped brackets to the frame above the front axle.
Replaced the bolts on the axle-side connection with spring-secured hitch pins.
When I go wheeling I crawl down there, pull the pins, and pin the ends up to the frame.
The clearance with the drive shaft is very close--but I don't have swaybar drops.
The hitch pins are obviously not as tight as the bolts, and you can here the bar knock around a bit when you go over bumps, when it is connected to the axle.
That is my only concern--worried I might where the axle-side bracket holes.

Hayes
 
If you talking about the front only.....take it off.

Wife ripped hers off in TX:o & has not noticed the difference since.
 
I've using the lynch (spell?) pin method for front and rear. Works well when the front is disconnected but the rear is connected. YMMV.
 
Back
Top Bottom