Subwoofer Enclosure

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I wonder what would happen if I try to so the same thing! My cruiser doesn't have that box on the side just the speaker casing, the vents and the ashtray!
 
Looks nice. That's a small ass Subwoofer. What does that sub push?
Also I wouldn't mount an amp behind back quarter panel. Those things need moving/flowing air running across them. Otherwise heat just sits there. But that's is a pretty nice amp so you might be ok, but that's why I wouldn't risk it either.
Either way, very nice and I like the stealth of it. Wish I could do that with my sub.
 
Hey I have a couple of NOOB subwoofer questions about your set-up:

1) why a fibreglass back-panel? Why not wood? Just a space/weight saver?


2) Why is the box supposed to be airtight? I ask because I built a small sub-box onto my rear cargo drawer system for a 10" Cerwin Vega sub. The first incarnation if the box was completely sealed and the sub sounded okay, but when I cut a small hole in the back of the box to mount something and forgot to re-seal it, it sounded way better. Wouldn't a completely sealed box limit the amount of rearward movement in the speaker cone, therefore limiting its sound?
 
The reason fiberglass back panel was used is to save space, plus the body curves and to accommodate for those.

The box design is suppose to be sealed. You can make a ported enclosure also but the port volume/length are suppose to be within spec from manufacturer. When you use cerwin vega speakers, most of them are for ported, not sealed. Especially the older ones like the cerwin vega, vega series 12" require 1.5 ft^3 of ported enclosure. This sub that I used only required .5 to 1 ft^3 of sealed. Different subs used for different things and different specs.

I am sure your cerwin vega sounds good, but it would sound better with it ported with the proper port length and volume.

Q
 
I was there yesterday at the Rising Sun Rally as Colorado80 installed that sub and amp. Really nice work. A great way to fit a sub and have it looking stock. After proper tuning it sounded great. Colorado80 then also tweaked the settings on my sub amp and explained what he was doing it (I have a 10" in a sealed enclosure built into my cargo drawers with an amp mounted on the side). Between the tweaks and the new infinity speakers in the rear doors (4022i) I have to say the sound is impressive. Next step is to disable the roof speakers and dash speakers and see how that contributes to clarity.

If I did not have my cargo drawers available space I would definitely have Colorado80 build me a box since he is a pro and has worked through the problems.

In my opinion there is ample airflow in the side panel since 1) there is a lot of open space around the amp 2) there are louvers in the panel and 3) the exhaust vet in an 80 Series sucks air through that body section.
 
Last edited:
Back
Top Bottom