stumped in so. or.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 15, 2006
Threads
2
Messages
6
Greetings. I've been reading here for a while, but never posted. I have a 91 w/ 165000 mi. It's a great truck, best I've ever had, but it's starting to drive me nuts. My odometer stopped working at 139999. I finally got around to replacing the speedo head at 165000(i kept tract w/ the tripmeter) but now I have no oil pressure gauge, and no radio! So I took it all apart and re-assembled it all but to no avail. I checked all the fuses, even replacing the ones that looked fine, but no difference. What gives??? Any ideas ? Oh yeah, I'd post pictures of my truck, but that is so far beyond my computer capabilities it's not even funny. If y'all knew how long its taken me just to type this...
And since I'm on a roll, I just did a tune-up, everything was working fine, but it was overdue. I replaced rotor, cap, wires, plugs air filter, oil & filter, fuel filter, and both air intake hoses. TA-DA, now it runs like crap! It starts right up, and idles, but as soon as it's warm, it stumbles and shudders and has very little power. I've double checked everything I can think of, all vaccuum lines are correct, (at least the same as they were before). Please tell me I've missed something obvious. Thanks for any help, and it's great to be associated with y'all
 
Did you use OEM plug wires? They are numbered to the cylinders so you shouldn't mess up the firing order. If you used non OEM then check your firing order. Track each wire from the distributor to the cylinder. Do this carefully as I missed this three times on another inline six I replaced wires on. It ran as you described with two wires crossed up.

Welcome.:flipoff2:
 
Thanks Flyrod I'll check that tomorrow. You might have seen my rig as I am also in Ashland. It's a sort of thrashed looking white truck with 33x12.50's and a damage multiplier on the front. You might have noticed I'm due for a front axel rebuild.
 
Thanks Flyrod I'll check that tomorrow. You might have seen my rig as I am also in Ashland. It's a sort of thrashed looking white truck with 33x12.50's and a damage multiplier on the front. You might have noticed I'm due for a front axel rebuild.

So am I. I have to do it before a big road trip to Utah this June. I'll let you know when I am going to do it. Good luck with this problem.
 
I replaced rotor, cap, wires, plugs air filter, oil & filter, fuel filter, and both air intake hoses. TA-DA, now it runs like crap! It starts right up, and idles, but as soon as it's warm, it stumbles and shudders and has very little power.

You missed a vacuum line. If it runs fine when cold and as it warms it starts to deteriorate, then it points to bad vacuum or bad O2 sensors. Since you just did a tune up and moved stuff around, I'd pay careful attention to the vacuum line drawing under the hood. Either you missed one or broke one.

FWIW, all the soft lines should be replaced and all the hard lines should be cleared as they're probably filled with poop anyway.
 
Back
Top Bottom