Struck Water Today

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 11, 2006
Threads
111
Messages
474
Location
Houston, TX
I had a previous post asking about my F block being plugged at the drain. Today I removed both fittings and starting poking around with an ice pick. I finally broke through to the point I had a good flow at the drain. Made me happy. Still plan to do a bit more flushing although the coolant was not that cruddy.Do you think this will make a difference with my overheating problem?
 
It can't hurt.

As I mentioned in your other thread, I dug down with a screwdriver through the water jacket holes with the head off one of my engines. The crud was layered up to 4 inches deep all along the driver's side :eek: ! Of course, you can't do that without taking off the head, but Prestone makes a chemical flush you can put in there, and now would be a good time to do that. I used the super cleaner. Be sure to follow all of the instructions and rinse before putting coolant back in.

http://www.prestone.com/products/coolingSystemTreatments.php
 
awsome man, i guess mine must be plugged alot worse then yours casue i couldnt even get through the crap to come close to water.................cheers
 
bretty said:
awsome man, i guess mine must be plugged alot worse then yours casue i couldnt even get through the crap to come close to water.................cheers
Howdy! Pull the radiator and flush it with muratic acid from pool supplies. watch where you dump it. Or send it down to local radator shop for a flush. Usually aroud $40. It will be beautiful, then. John
 
yah the rads been flushed twice its the block thats plugged!!!!!!!!!!!!!!!!!!!!!
 
Can you post pics of where to check for this? I'm going with an all new cooling system on my F and want to check this out before I start putting it all together. I was going to replace all the freeze plugs but they all look good at this time.

Thanks
 
Don't piddle with the freeze plugs if you don't have to.

The drain is on the driver's side to the rear of the block and low.
 
IDave said:
Don't piddle with the freeze plugs if you don't have to.

The drain is on the driver's side to the rear of the block and low.

Thanks, thats where I thought it was. I agree on the freeze plugs, but I wanted to make sure I didn't have any starting to rust through. I had one on my 70 model that had a rust hole and when I scraped it with a screw driver it became a leak. I didn't want any suprises since I'm replacing everything with the cooling system.
 
Back
Top Bottom