Stripping a 93 FJ-80

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 2, 2006
Threads
56
Messages
159
Location
Asheville NC
Location
United States
I bought a good fj-80 with 175,000 miles. i am going to use the axles in my buggy but need to sale the rest. Just seeing if anyone needs some used parts.? The body is great except for the front driver fender and front bumper.
 
REAR WIPER MOTOR!!
(if it works)
 
I want the starter.

...

Also all connectors [male and female] and relay ECU units.

...
 
Last edited:
rear wiper arm :)
 
Where be ye located?
 
parts

I will have the cruiser home next weekend. I was checking if I could sale parts off of it. I am located in Asheville North Carolina. I was supose to have it here this week but my plans went all to hell so it will be next weekend. I have all the parts that have been asked for but can't tell you that all of them work until next weekend. I will post up again when it rolls into the garage.
 
Please test the rear wiper motor before you pull the battery. Many don't work after a few years.

I will be going overseas next weekend for 10 days, if I don't respond to your PM's right away, give me some time to get back in the country!
 
93 lc parting out

I'll take the right rear door, if not rusted and the front passenger side fender flare. Heck, if the grill is in good shape, I'll take that too...

And also the rear tailgate (lower portion)

Dave....

PM me for price.....
 
rims?
 
I need one center cap, front driver side fender, and front driverside fender flair.
 
Cargo area carpet if it's tan/oak and not all smelly and nasty.

Left rear quarter red marker light + housing.

Left rear taillight lense.

Right front turn signal lense.
 
I am looking for the following:

CDL switch
ac compressor ( if r12)
rear hatch supports (if still good)
Drivers side mirror (complete assembly)

Thanks
 
Cruiser Parts

UPDATE!!! The cruiser will be here tomorrow so I will test the parts ask about and get back with everyone tomorrow night. If anyone want's to call it is 828-243-3698.
 
i need the ecu if it is a late build 1993. can you check the manufacture date on the driver door and if it is after say june 93 check the p/n on your ecu. and the ecu is a steel box in under and behind the glove box.

if it is 89661-60170 or 89661-60220 i can't use

if 89661-60221 then i want it.
 
Back
Top Bottom