Stripped Spark Plug Hole....

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 18, 2005
Threads
125
Messages
1,714
Location
Louisville, Kentucky
Since I have owned the 40, the third spark plug hole has always been a bear to install all the way in and to remove. I believe it has been rethreaded? by PO trying to monkey it all the way in. I still cant get it to go as far in as the other plugs(three or four turns less than the others). First is there any consequences for having it not as far in as the others,(not very much at all but still not as far as the others), and #2 how can I remedy the situation?
 
They make spark plug hole taps. I've seen em at carquest, if you have such a place in KY. That's what I would use. Yes, the placement of the spark in the chamber can, to some extent, affect your running.
 
So after a tap, I'd still have the same diameter I would imagine??
 
I'd think it would clean up the threads just fine.
 
Spark plug taps are a bit different than "normal" taps they are more open to cut carbon deposits. They are more like a thread chaser, the idea being to "clean-up" the threads as opposed to cutting new ones.
 
So should i stuff something in the hole to prevent shavings from entering the head or??
 
Load the tap with grease to catch the crud, or get the intake valve on that cylinder open . hook up a air line blowing into the carb so it will blow the crud out of the hole and back into your face
 
cabron said:
So should i stuff something in the hole to prevent shavings from entering the head or??
I wouldn't do that - you might not get it out. Grease the tap and use a small magnet like the pointer type that are sold everywhere to get as much as you can out, then turn the engine with the starter, coil disconnected, to blow out anything left.

There are also Helicoil sparkplug hole repair kits that put a steel threaded insert into an otherwise unrecoverable hole.

The sparkplug seals on it's shoulder and it needs to thread all the way in to seal.
 
The spark plug repair kit is actually a special insert rather than a normal helicoil. Do a google search for it and you'll find all kinds of vendors. You should be able to easily do the repair with the head on the engine, just use the greased tap trick. Good luck.

Here is an example of the kits that are available.
153118_072820051764_ExhibitPic.webp
 
thanks for the responses!!
 
Back
Top Bottom