Straigten my steering wheel...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 10, 2005
Threads
178
Messages
4,621
Location
in the nappy dugout
how the hell do i get my steering wheel back to zero.....:confused:

When my tires are straight my steering wheel looks like i am turning left - anyone know??
 
Well you can remove the wheel and re-index it or you can adjust the drag link. First I would want to know has it always been this way or is this a recent issue?

yep, always been dis way........

It doesnt effect anything, it just looks funny going down the road.....
 
If the truck tracks true and there are no weird tire wear issues then I would just re-index the steering wheel. All you will need is a cheap steering wheel puller. Get the wheels straight, pull the wheel off and align it true.
 
If the truck tracks true and there are no weird tire wear issues then I would just re-index the steering wheel. All you will need is a cheap steering wheel puller. Get the wheels straight, pull the wheel off and align it true.

that is what i had figured.......thanks
 
i had that problem when i installed my 4" lift, wheel rotated about 15 degrees. i adjusted the drag link in small increments, driving it around in between to get it just right. also went through a can of penetrating lube....
 
Drag link is the "tie rod" between the pitman arm and the passenger side steering arm. Since it threaded opposite at eachend you can twist the drag link and shorten it turning your steering wheel to the right or legnthen it turning your steering wheel to the left.

Chris
 
If the truck tracks true and there are no weird tire wear issues then I would just re-index the steering wheel. All you will need is a cheap steering wheel puller. Get the wheels straight, pull the wheel off and align it true.

You might be able to get it off with out a puller. Once you got the nut off, get your knees behind the steering wheel, and use them to put pressure on the steering wheel (pushing it off the shaft), then give the steering shaft a good wack with a hammer and the steering wheel should come off. If not go get a steering wheel puller.
 
If you have stock steering components, you can adjust the drag link (between pitman arm and center arm) or the tie rod (between center arm and pass side TRE). If you have Sag P/S adjust the tie rod between pitman arm and pass side TRE.

Find center of Lock to Lock position, then make the adjustment until steering wheel is in the correct position. Leave clamps loose, drive in a straight line and adjust if needed. Then tighten things up.

I wouldn't just reposition your steering wheel. You might not be in the center of your turning radius???
 
You might be able to get it off with out a puller. Once you got the nut off, get your knees behind the steering wheel, and use them to put pressure on the steering wheel (pushing it off the shaft), then give the steering shaft a good wack with a hammer and the steering wheel should come off. If not go get a steering wheel puller.



I would not remove the nut all the way, but rather, leave it flush with the top of the steering shaft as it is easy to damage the threads on the shaft if the nut is not there to protect them...



:beer:
 
Back
Top Bottom