Steering wheel jerking

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 7, 2007
Threads
8
Messages
23
Location
Alamance County, NC
Help please. My 1997 fj80 brakes were replaced just a few months prior with heavy duty Aussie rotors and pads. Upon application of brakes, steering wheel excessively vibrates and truck shakes. Steering seems to work fine. I drove to the snowy mountains yesterday and problem seems more pronounced.
 
A few ideas:

bearing preload not set right
warped rotors
loose calipers
loose wheels
loose rotors on hubs
 
All above, not installed properly (whatScO said) or not broken in properly, build-up of material on the rotors can do it (glazing). Rotors can get warped by abusing them ie: by keeping your foot on the pedal causing them to get too hot like when going down a long mountain grade. Improper tightening of the lugnuts can cause it too. A stuck caliper piston which causes the pad to drag on the rotor will cause too much heat and warping; this can happen in one day, or less.

If someone else installed it all; take it back now. Many dealers will charge you again (likely) if over 90 days since the install. You might want not to mention anything about mountains when you take it in.
 
Sounds nasty mate, are you sure a workshop did the job?
Why wouldn't you take it straight back if the job is up the s***?
Did you do it yourself?
 
Back
Top Bottom