Starts then dies

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

ygthb

MUD Addict
Joined
Jun 16, 2013
Threads
11
Messages
111
Location
Kyle, TX
94 FZJ80 - starts fine, dies in 3 seconds. doesnt matter if throttle applied. pulled and cleaned the fuel pump relay.

New video by Arthur Trevethan - video

Normally I would have time to look for a solution, But I have very limited availability today, and the truck is packed to go camping tonight at 7.

Looking for suggestions quickly please
 
Could be a few things, but I can tell you what it was when mine did the same thing. On mine it was a open fuel pump resistor(heat sink looking thing mounted to the the front passenger side inner fender). Pretty easy to eliminate that as a possibility, unplug the resistor and jump the terminals on the harness side of the plug, if it runs that way its the resistor.
 
So I thought I had it licked, cleaned the contacts on the fuel pump solinoid in the recess of the drivers side fender, removed the maf and cleaned it. Started and ran. Then as I am ready to leave for the trip back to start and die.

Here I sit, not in the woods, with a swollen right hand from punching and destroying the windshield. I really need a few days in the wild with my dog.
 
Might want to go with a different type of vehicle if your gonna beat punch things when you have an issue. These things are very fixable but still 25 year old trucks. Things break
 
So I thought I had it licked, cleaned the contacts on the fuel pump solinoid in the recess of the drivers side fender, removed the maf and cleaned it. Started and ran. Then as I am ready to leave for the trip back to start and die.

Here I sit, not in the woods, with a swollen right hand from punching and destroying the windshield. I really need a few days in the wild with my dog.
You don’t have a maf, so what did you clean? Hopefully you didn’t undo the screws
 
Sorry all, was just experiencing extreme frustration. been a stressful month and needed time in the woods. I did not remove the screws from the vaf, just pulled it, cleaned the connections and the door. I have restored my peaceful state and will be doing more tracking down of bugaboos,
 
The fuel pump relay switches to high speed to start, then low (through the resister) to run. If there is a failure in the low speed circuit (relay, resister or connection) it will die after start. Confirm by unplugging the relay and jumper term #3 to #5 on the connector, if it runs, you have found the problem.
 
Back
Top Bottom