Starting problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 16, 2005
Threads
9
Messages
37
Location
Dothan, AL
I recently purchased a '72 FJ55 that had been sitting up in Fox, AK for about a year. The guy I bought it from tells me that the engine was rebuilt about 100 miles ago (not sure if I believe him or not). The car ran great up until when I started messing with it. I changed out the spark plugs and took it out in the snow for a quick little off-road jaunt. Halfway through the trip she decided that she didn't want to idle any more. If I don't give her gas she just dies. She has no problem cranking up and will even start just fine now. However, once she starts she immediately dies unless I keep the pedal floored. The only thing I can think of is maybe there was some buildup in the tank that was jossled into the fuel line and is clogging it. Any suggestions would be welcome. Thanks


PS It is currently -30F in Fairbanks
 
The first thing I would check is the hose from the PCV. I had them come loose and the engine doesn't want to idle because of the large vacuum leak. The stock hose is hard on my 68 and wants to slip off where it goes just under the carb.

John
 
If you suspect fuel pressure, then I'd just disconn from the carb and crank it to see what kind of pressure you're dealing with. If good pressure then I'd let it run itself til she dies (no pedal) and then open the bowl and see if it's full or empty. If empty then obviously adjust the float needle valve to allow it to fill up (not to overfill though).

Stock carb???

That is @&@&@&@&in cold man. :frown:
 
If your carb has an idle cut-off solenoid (Toyota put one in there when it made the truck--what POs have done is anyone's guess), I'd suspect that it is not functioning properly. Maybe the off-roading disconnected the wire.
 
Find the idle solenoid [cylinder on backside of carb tucked underneath the accelerator pump arm] disconnect the single terminal that plugs it into the wiring harness and try jumping the terminal directly to battery + and see if you can here it click.

If it doesn't click, then chances are it's bad.

If it does click, then turn the key to the on position and reconnect the wire back into the harness where you found it and see if it still clicks.

If it doesn't, then you've found the problem: bad wiring. You can run a wire for the solenoid directly to coil+ until you track down the problem.

If it does click, then try starting the truck up and see if anything has changed. Report back.

:)
 
Thanks for the help. I checked all of those things and it turns out the wire from the cutoff solenoid had come disconnected. I learned some things from all of your suggestions. Thanks again 65swb45. There is no sweeter sound than to crank her up and hear her purr.


PS To say that it is @&@&@&@&in cold is a bit of an understatement. How long have you been flying 60's? I'm a 47 guy up here and I just got back from the sandbox.
 
jorj54 said:
Thanks for the help. I checked all of those things and it turns out the wire from the cutoff solenoid had come disconnected. . . . Thanks again 65swb45.
Come on man! I beat him by 9 hours!:D
 
Back
Top Bottom