Stalling on decel after MIL code reset

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 5, 2013
Threads
9
Messages
44
Location
Nashville, TN
Hey gang,

So after nearly 4 years of blissful Cruiser ownership our family's needs have changed and it's time for my super clean '94 FZJ80 to find a new home. In preparation for getting it ready to sell, I started going through all the pesky little things that never bothered me but really should be addressed before sending it on to a new owner. Most of this list entailed minor trim and electrical issues (burnt out dash lights, for example) but I also felt it was time to clear out the MIL light that comes and goes for time to time. The code is always a 71 (EGR system error) but it never affects how the truck runs and, after a lot of investigation with no permanent results, it really just seems like a gremlin in the old first gen OBD system.

Anyway, after confirming (once again) that the code really was a 71, I did what I normally do to reset the MIL light (pull EFI fuse, wait 30 sec, plug the fuse back in). Normally this works as expected--MIL light goes out, truck runs a bit rough for a day or so at the system "relearns" your driving patterns, then it smooths out again--but this time the truck always wants to stall when I have to slow to a stop, which can be a bit hair-raising especially when trying to make a turn and you lose power steering halfway through the turn. I've been trying to drive it at different speeds, etc to get through the "readiness cycle" (if indeed it's the same as what you normally have to do for an OBD-II vehicle) but so far to no avail. Truck is still stalling after about 90 minutes of varied driving. No more MIL lights have come up either, btw.

Anyone have any ideas about what I should be checking here? This rig is bone stock mechanically with only about 205k on the clock, and as I said it was running fine before I pulled and replaced the EFI fuse.

Also, while I've got your attention here, can anyone point me to a concise walkthrough of how to change the plugs and accessory belts on a '94 FZJ80?

Thanks, guys.
 
Hmm, interesting. I wonder if the ECU harness by the EGR is being affected somehow. How does the harness look by the EGR? Usually they're a bit crispy critter due to age.
 
Back
Top Bottom