Spongy Brake Pedal

[KLF]

Pretty sure this is the proportioning valve I have:

http://www.summitracing.com/parts/wil-260-8419

I think I was planning to get some 1/8" adapters, something like that.

Honestly, I can't remember the residual valve I have, I think it's this one:

http://www.summitracing.com/parts/wil-260-3278

I do know I bought them all from Summit. Or maybe Jegs.

I'm an old guy, and it was a long time ago, OK?

Wait... what were we talking about again?

 

[TRoss]

Pretty sure this is the proportioning valve I have:

http://www.summitracing.com/parts/wil-260-8419

I think I was planning to get some 1/8" adapters, something like that.

Honestly, I can't remember the residual valve I have, I think it's this one:

http://www.summitracing.com/parts/wil-260-3278

I do know I bought them all from Summit. Or maybe Jegs.

I'm an old guy, and it was a long time ago, OK?

Wait... what were we talking about again?

That's what I used...

http://s116.photobucket.com/user/TRoss5/media/85 Truck/DSC03037.jpg.html

http://s116.photobucket.com/user/TRoss5/media/85 Truck/DSC03040.jpg.html

I think we were talking about bacon???

Oh.. to the op, make dang sure your calipers (frt and rr) aren't on the wrong side. Bleeders should be UP. And yeah, it takes a ton of bleeding... mine did anyway. And when you do the disc conversion, don't be too disappointed. The prop valve will probably be adjusted full rear bias just to get it to balance (mind did) And the brakes get spongy over time as the pads wear and the wobbly axle flanges (typical Toy) push the caliper puck back in.... just sayin'