Split case output Bearing

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 3, 2004
Threads
103
Messages
614
My 81 splitcase front output shaft as a whine and play in it. the case was rebuilt shortly before I bought it. The seal is not leaking and it sometime slips out of 4wheel drive even in low range. the drive shaft yoke is bad. that is getting replaced. My question is can it be the needle bearings in the end of the output shaft, assuming that it has them, I have just worked on solid cases in the past and looking at SORs diagram I am a little lost as to even what is the front shaft. Maybe its the cold mediciene I am on as nothing is making much sence.

Myrle
 
It sounds like you need to rebuild it.

The front output shaft is supported not by a roller bearing, but by a caged ball bearing. The rear end of the output shaft is supported by tiny needle bearings pressed into the front end of the rear output shaft. The only way to get a look at any of it, is to split the case. If you are going to that much trouble, just do a rebuild.

The front output bearing may not have been replaced, though it doesn't get much wear either since it only turns when in 4wd. Play in that bearing is not normal, though, so you have likely found the problem.

What is wrong with the drive shaft yoke? That's an odd one as well.
 
Thanks for the reply, the yoke is just worn out. it has a lot of side to side movement when it is wiggled. I have an older yoke here and it eliminates the slop. I think the truck was driven a lot in 4wd in the hard surfaces.

I had not even thought that the splitcase would not have a removable cone as the older ones. time to pull up the FSM.

Thanks
 
What kind of play in the output shaft? Rotation is normal; anything else is not. Whine is usually gear noise, but it can be caused by bearings allowing the gears to tilt on their shafts. Broken motor mounts can knock the Tcase out of gear.
rule out the simple things first before you dig in.
 
What kind of play in the output shaft? Rotation is normal; anything else is not. Whine is usually gear noise, but it can be caused by bearings allowing the gears to tilt on their shafts. Broken motor mounts can knock the Tcase out of gear.
rule out the simple things first before you dig in.


mounts are good, play is up and down and with no leakage from the seal I am sure thinking of the needle bearings, maybe the replacement of the driveshaft will correct it enough for now but may have caused this other problem along with the fact that I am loosing oil to the Trans and it got fairly low before I noticed. but if the driveline is not packed with grease I have to leave it in 4wd when the hubs are in to keep the vibration down to a managable level when on the road. this did not become apparent until the snow hit because it was the first time that I used the 4wd on the road before it was in the woods.

I am thinkg that I will order up the bearing kit from SOR at this point and have it on hand if I have to drop the case.

Thanks, Myrle
 
Back
Top Bottom