spindle bushing lube tool

[PurpleFJ62]

On here many months ago and there was post about someone who made a special tool to push grease into the inside of the spindle. To the bushings. It was something like a cast iron pipe end cap that was tapped for a zurk and then you put your grease gun on it and then you could back the spindle bushings w/o having to remove the shafts. I am going to try to make a tool like this. Would love to know more, like the pipe thread and size.

thanks -nate-

 

[Tools R Us]

Beowulf over on the 80 forum made one;

https://forum.ih8mud.com/showthread.php?t=85389

 

[PurpleFJ62]

thanks for the link. I know I saw it before, but why would I be looking around in the 80 section to begin with...haha.

thanks much.