Someone Pee'd in My Cheerios

[We Don't Rent Pigs]

Someone Pee's in my Cheerioes and put milk in my crankcase. I think my 1f cashed out it's headgasket. It's been sitting for about 3 months, Before I ran it I checked the fluids and noticed milk in the crankcase when checking the oil. I backed it outside to look things over a little better. After just running it for 30 seconds I proceeded to check the coolant and there was a substantial amount of pressure in the radiator. Lucky me. It maybe time for the 4.9 Ford Swap soon. Anybody wanna buy a pig? Hehe

 

[jimhendrixx]

WTF, i say it again, WTF?!

 

[hicruise55]

How much are ya selling it for, any pics? Sounds like a HG to me, not hard to replace though.

 

[Southeast Overland]

Pull head, replace gasket, replace head - maybe get head rebuilt while you are at it and in the mean time replace fluids and you should be good to go!

 

[We Don't Rent Pigs]

Let the games begin!!!
I hope the head isn't cracked, any recommendations on where to get a HG????

 

[wesintl]

any recommendations on where to get a HG????

OEM Toyota is the best bet on a HG

 

[hicruise55]

OEM Toyota is the best bet on a HG

X2 probably the factory one in there! 33+ years!?!

 

[Pighead]

Do a compression check before pulling the head...maybe sitting for 3 months can turn your oil milky? Was it sitting inside or out?

 

[toddslater]

Pull the head and have if checked for cracks and warpage. If warped, resurfacable ? If cracked, replace it. If neither, put in a new head gasket and your good to go. Lastly, if it were me and the head is obviously off, I'd probably look at having hardened exhaust seats put in. The F in my 73 is still going strong unre-seated, but when it has to come a part (if ever) I'll probably do it.

 

[We Don't Rent Pigs]

It was sitting inside Pighead, I may chance my luck and change oil, fire it up and see if it was just condensation. But there was quite a bit of pressure in the radiator just running it a short time. Thanks for the help everyone

 

[toddslater]

Water in your oil or worse antifreeze in your oil can eat you bearings in pretty short order. Something to consider while your wishful thinking. Over pressurized rad, cheerios and milk in your pan...you know what you need to do. Good luck.