someone knows the answer

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 28, 2005
Threads
71
Messages
437
Location
spicewood,tx.
getting close to the end. 355 sbc, blah blah. with a hei dist and rams horn manifolds, what do you do about plug wires?

does anyone have a suumit, autozone,etc. part #. shoulld it be a universal kit? also, where cani find the little thingys that retain the wires to block away from the manifolds?

any ideas? thx jim
 
I just went to the local auto parts asked for plug wire set that can be cut to length. also they will have wire bracket to hold plug wires away from headers
 
Get some straight boots and wires from JEGS or Summitt. Shipping is free..


90s tend to not work real well with ram horns, straights will work well..

I second the straight boots,90's are a PIA,
 
youall have any pics? maybe the corpus guy?

the least problem might be over vale cover type, but they do not look the cleanest. today i picked up a set of supposedly big block wires from the local autozope. just hate buying a new set every couple of days, plus its 40 miles r.t.

jim
 
getting close to the end. 355 sbc, blah blah. with a hei dist and rams horn manifolds, what do you do about plug wires?

does anyone have a suumit, autozone,etc. part #. shoulld it be a universal kit? also, where cani find the little thingys that retain the wires to block away from the manifolds?

any ideas? thx jim

Stock Ram Horns would use the 90 degree boots at the plug if the wires are run as stock under the manifolds and to the back of the block before running up to the distributor.

I found a premade set for routing that way awhile back but it was for a points distributor, not HEI.

I was not able to find the clips aftermarket. I even went to GM Parts. They knew what I wanted but didn't have a source. I eventually found a set of clips at pick-n-pull. Pretty simple, you could make some too. Just thin metal that mounts to one of the oil pan bolts. One on each side of the oil pan. Clips have a bend to clear the oil pan rail. Here's a crude picture:

.
ramhornwireclip.webp
 
i have about the same setup and i used the universal kit with 90* boots on both ends. i ran the wires on the intake side of the rockers with front four wraping around the front and the rears looping down the back. this keeps everything away frome the exaust. when i did it i needed the 90* boots and short plugs for clearance on the drivers side, but your engine placement may be diferent.
hth, carl
 
Back
Top Bottom