Soft door Q's

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 21, 2005
Threads
963
Messages
9,414
Location
Powell River, BC
I just picked up a newtome bestop top and doors to replace my aging and rotting current bestop top.
Silly me just assumed it will all fit over the hardware etc that I have now. I havent actually fitted the top yet, but the doors are quite different and dont match my strikers.
I suppose a little background is in order. The 40 is a 1974 (oct 73), and the top is a 'bestop' brand as previously mentioned, of at least a 15 year vintage.
The old doors have the handle that sticks way out, with the plastic covered flatbar that hooks on the inside roundstock b pillar for the soft top (see pics).
The new doors have the flush mount handles, but the latch comes no where near my door striker plate.
I compared the striker plate to my '82 fj45, and its way different again, with a formed c-bar for the hard doors on it latch to.
So, is there a striker plate off of a different year 40 that will bolt on? or keep my old doors and sell these new ones?
And now, without any further ado (and using my newly acquired silver star!)..pics!

first pic: existing door striker (passenger side)
2nd pic: existing door latch (interior view, drivers side)
3rd pic: 'new' door, passenger side.
PA300154.webp
PA300156.webp
PA300157.webp
 
Last edited:
Reversing the strikers would not appear to work after having a thorough look at it. The doors just would not pull in far enough. That, and the bolts fastening the strikers in apparently have the end of the threads mushroomed because they all tighten back up once the striker plate is loose.
The easiest alternative looks like fabbing up some thin plan bracket and fastening that to the existing striker somehow. I'll have to draw it up and study it a bit. But not as easy as it first appeared anyways.
I sent bestop an email with a couple questions on it as well, shall see what happens.
 
Just a little update on the door problemo. Managed to get the striker bolts out, but stripped all the bolt heads out due to that 'mushroomed' end on all 4 of 'em.
Anyways, reversing the striker would work, but I'll have to grind out the chamfered thickened section in the middle in order for it to work. Looking at a friends 40 this weekend that had the same doors, his doors came with a flatbar type striker plate to replace the stock one.
 
I fabbed a set of strikers for same style of soft door from 1/2" or 3/4" 90 degree aluminum stock from the hardware store. using old strikers as template, cut to length, drill 2 holes in each. bolt to door jamb with leg to outside of jamb, grind down leg until door closes properly. Simple and works fine. Or buy from SOR.
 
I have a Bestop Tigertop, with 1 piece soft doors. Tha latch from SOR is the same one that came with my doors. For $10.00 I would buy from SOR.
 
My Bestop doors came with new strikers, suggest you get onto Bestop, even if you didnt buy them new the Bestop guys are really friendly and helpful - they shipped a Jeep (sorry) part that I was missing on a used hood I had within a week free of charge (and I'm in the UK!)
 
Back
Top Bottom