Sliders tomorrow...Hanna here I come!

[Junk]

I'm going for the caps rather than the mud flaps based on cost alone.
I'm a cheap bastid sometimes.

sometimes

 

[Slomo]

I did an even cheaper fix. I just trimmed the running board end cap level with the ground just below where it attaches to the flare itself. This eliminates the portion that curves back to merge with the running board. It wound up about 2 inches wide and covers the end of the flare to give it a nice finished look. Free no less.

 

[Brentbba]

I used the mud flaps from CDan, about $100 for the set. I trimmed them to go over the slider and they came out nice. So if you can't get the caps from Slee you can make the mud flaps work.

Some people don't like the flaps or wheel hard enough to just rip 'em off which is fine. The flaps actually keep a lot of mud and grime from flinging up the doors. I won't complain until one gets ripped off Love the sliders too, bolt up great and the cat protection works well...found that out already.

Pics avaiable upon request.

Did this exact same thing. Very happy, but admit I thought long and hard about Slee's cap. It's a nice product.