Shock r&r how-to?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 16, 2007
Threads
17
Messages
100
Location
Jupiter, FL
Hi guys, I've searched and searched and other than little tips and tricks, I have been unable to find a full write-up for removal/replacement of shocks for my 93 TLC. I keep seeing referrals to FAQ, but I guess I'm a :confused:dullard:confused: because I haven't found a useful FAQ link. I just ordered a set of OEMs from Dan and want to be ready when they arrive. Any insight would be appreciated.

Thanks,

Jason
 
Blast all the mounts with penetrating fluid well beforehand paying particular attention to the rear upper and lower. If you are in a "rust belt" take your time when freeing rusty nuts and bolts as they have a tendency to break causing undo stress, sometime a little heat will help.
Try heat then fluid over and over, also loosen then tighten frozen nuts in cycles till the parts move easily.

Make sure you put them back in the same way they came out. Normally the thicker tube end is on top allowing dirt and water to exit via gravity.

Save your shock washers as some companies do not supply new ones...
 
2nd "sticky" thread on every single page of the 80-Series Tech Section is "Newbie's Check Here First". You should have been checking here numerous times. Right there in the post is a link the the FAQ.

I strongly recommend reading the many posts on lifts and the various options you have, but if all you want to do is know how to install shocks then go to this link on Christo's website.

Slee Offroad lift instructions: http://www.sleeoffroad.com/technical/tz_ome.htm

-B-
 
Thanks guys. I have been frequenting the noob link, but I guess I just didn't look closely enough. The Slee pics help, thx B, as will Riley's write-up and Squash's tips. I've done shocks/struts on an old M3 I had, so I have an idea. I'm just trying to find as many LC-specific nuggets as I can.

Thx again.:D
 
Back
Top Bottom