Safe spot to drill driver side firewall

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 1, 2015
Threads
51
Messages
1,490
I'm trying to feed about 1/2 inch of bundled wires from the inner driver side pillar to the engine compartment to my bussmann fuse box. Can anyone tell me where it's safe to do a 3/4" cut out in this area? I'll of course have a rubber boot to put on place. Thank you

1473635060362714204144.webp


1473635095362331180974.webp
 
So for anyone that may need this in the future. Just above plug closest to fender it's safe to drill.

20160913_175208.webp
 
I usually just poke through the factory boots to add more wires. I know both sides of my LC accommodated quite a bit more than what was already there. Saves blasting new holes. Still good to know that's a possible spot on a 2001.
 
I usually just poke through the factory boots to add more wires. I know both sides of my LC accommodated quite a bit more than what was already there. Saves blasting new holes. Still good to know that's a possible spot on a 2001.

I've done that on the driver side for a small wire, but this bundle was too big I would of slaughtered the existing boot. I'll post pics after new boot installed its clean look waterproof, and large enough to not strangle power lines, just like the stock OEM.
 
Carefully make a hole in the big rubber wire harness cover on the passenger side. There is a lot of room there.
 
^ lot's of room.
 
Well so you guys know what I meant :) not sure how to correct the title for future use. I would normally make an incision in the exiting boot but this harness was too thick. Anyways point being that's a safe spot for anyone looking to do the same for an inch wide harness. I'll post a pic of the finish product with an aftermarket boot.
 
Last edited:
@savirc I have a 04 so it may be different, but can you tell me what was on the other side of that hole? Did you have to remove a bunch of stuff in the cabin? Here is what I see, its hard to tell what's behind that big white box.

Did you just fish around back there until you found some wires?

IMG_8280.webp
 
Updating this thread as I recently used it to find a location to pass some wires (Ecoflow alternator charger) through the firewall.

I used the same location as savirc (OP) did, but I accidentally put a tiny hole into the return mixing box (referenced in the previous post) using what seems to be the same step drill bit as he did?? I wasn't at the 1 1/4" hole size either at that point. What I ended up doing is ordering a 1 1/4" inch drill bit, putting metal tape over the hole I created on the mixing box, and then finished drilling the desired hole size for the grommet that I used.

I then ran a wire coat hanger (cut of course) down the hole into the passenger foot well so that I could make a hook and put the end of the wire onto it and drug it through. Once I had the desired wire length into the engine compartment I pushed the grommet down the wire from the engine compartment and pushed it into the hole (it fit nice and snug).

I'm happy with the end result:
1000013795.webp

1000013796.webp
 
Back
Top Bottom