rust

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 6, 2004
Threads
234
Messages
4,449
Location
Bozeman, MT
I opened up my spare axle today to that I could pull out the diff to weld up and swap it with the diff in my cruiser. When I got in there I noticed it has some surface rust on it. I was just wondering if you guys think it is still useable in this condition or if I should sand the rust off and rust block it would it be ok. Or should I just go ahead and yank ther other diff to weld.
 
From what I can see of the gear tooth faces, they look like they would probably be ok. But your pictures are a little blury so its kind of hard to tell. With that amount of rust in there, I would be more concerned about the condition of the bearings. I wouldn't run it until I took it apart and inspected/replaced them as a minimum. Even welded, you need good bearings.
 
Not to steal the thread but is that big ring gear the one that gives you the 4.11 or 3.73 etc. ratio? If not then where is it/are they? I'm planning on doing the switch to 3.73s for highway speed sometime and thought, with the picture there, it was a good time to ask. I looked in SOR catalog and the Haynes book but can't find any details. Another rookie question ,is the figure thhe ratio of the driveshaft rotations to axel shaft rotations?

Thanks in advance,

John
 
Your ratio is usually made up of a combination of ring and pinion gear sizes , that is why when you order gears for axles you don't just get a ring gear.
 
I dont know whats up with all the rust. I got this as a freebie for buying the engine I put in my cruiser. So I decided it would be easier to just take this one and weld it then switch it with my cruiser's so my cruiser wouldnt have any downtime. Turned out to have some rust in it but I'm just gonna drop some osphos on it before I weld it up. Kill that rust then the gear oil should protect it well enough.
 
Back
Top Bottom