Running a "T" for Sending Units

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 28, 2003
Threads
311
Messages
3,962
Location
Crawlorado.com
Website
www.crawlorado.com
in my SBC i have more Sending Units than spots for them.. they are all 3/8..
At the Thermostat i have one for the Computer
at the left side of the head i have one for my Guage

Now i am adding a Sender for controling an electric fan, Id rather have it at the Thermostat

Is it OK for me to run a "T" fitting and have two senders into it, or will it mess up the Readings too much?

Or should i Try to Get the plug out of the Right Head and use that??
and how would one go about geting that Square Plug out??

:cheers:
 
I have installed temp sending units in the side of the head and in the stat housing...I really do not see where the T fitting would be an issue, so long as it did not create an air pocket somehow...


That square drive plug uses a male square drive socket, and should come right out....some are the same size as a 3/8" drive...


Good luck!


-Steve
 
I tried with a T in the place where the stock sending unit is located, top of the head near the thermostat on my tbi, and had probs. I think there was an air pocket. I tried adding in a bleeder valve to bleed it, but once the rig cooled and the water pressure dropped, a new air pocket would form. Its probably possible to get it to work, I just didnt have good luck. I ended up installing the sender in the side of the block on the passenger side. Summit has some water necks with plugs that I am looking at buying.

-Dustin
 
Back
Top Bottom