RTH: starter won't let go

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 19, 2005
Threads
59
Messages
1,733
Location
Small Waves, FL
In the middle of replacing the starter. Battery disconnected, starter unplugged, both 17mm bolts out but the starter is "stuck" to the engine.

Did a quick search on Mud, tapped on it a few times with a hammer, used more force with both hands, won't drop.

What to do?
 
Put one of the bolts half way in so you don't drop it. Get a scrap 2x4 and use it so you can wack the starter body form above and below. You should be able to get a good swing at it using the board to get the hammer in a better position.
 
I'm hitting it with pretty good force using a 2 lbs. sledge against my breaker bar from the side and below.

The starter won't budge.

Any other ideas? In the meantime I'm going out to beat my starter!
 
So I had the great idea of using the bottle jack and a short 4x4 to apply some pressure, then a floor jack and a pipe on the bendix.

Found a new jack point.

A second pair of eyes observed that I had removed the 17mm bell housing bolt and the rear/lower starter bolt was still in.

Strong bolts.
 
Wish I could say crap like that never happened to me......:doh:
 
Back
Top Bottom