RTH-My tailights are missing, electrical gremlin

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 26, 2008
Threads
28
Messages
354
Truck - 1994 LC
Problem - missing taillights and missing license plate light (however turn signal, backup lights, brake lights are working no problem)
What I did troubleshoot so far
1. Front headlights work, so do small bulbs on the side of the headlight (are those clearance marker lights?)
2. Fuse for taillights works and gets the power.
3 I checked big connector hidden under the jack on the driver side rear (On the picture labeled BQ1) and there is no power to the the pin # 4 which should be taillights.
On the picture below Blue arrows point to where power can be found, reds where is missing
Tailightsschematic.jpg



Now I am looking for plug ID2 which should be big plug on the side of fuse relay. But there is nothing there. Am I looking at the wrong spot ? Picture below
ID2Location.jpg


Here is the pic of the plug
ID2Plug.jpg


I mean plug is hard to miss I would imagine but nothing there. Any chance somebody who has his kick panel out take a pic of the area? I can not be missing the plug but then again who knows.
 
You need to really dig in there. Those drawings in the FSM are not always "intuitive". That connector looks to be north of the relays in the kick panel. Possibly behind the fuse box by the driver's left knee. Dig into it. It'll be there.
 
Wow...Good leg work so far!

Unfortunately I have nothing to add/suggest other that bump you to the top and wish you luck!
 
Update: SOLVED!!!! I Have lights again.
Ok I dont have pictures but there was not much to see there anyway.

but few info Items

ID2 plug is located almost in the spot where FSM says except it is closer to firewall and right under the kick panel. Easiest way to find it is to remove trim next t o driver seat (from the door side( and find big bunch of wires. Trace that and you will find ID2

So what was the problem...
I have leaky sunroof that I am having problems fixing. That makes my carpet wet on driver side. PO had some hookup made into the wiring harness. Electricity + water + trip to vacations = corroded wire and no lights.
I had re soldered connection and dipped in RTV Grey Silicone (safe for sensors) and wrapped in electrical tape.
:cheers:
Few wisdoms.
1. In case of electrical issues with rear unplugging the rear (B22 big plug located under the bottle jack on the driver side rear) is the way to go. Rear and fronts are independent (Kudos to Toyota for smart desing.)
2. Testing between ID2 and B22 helps to rule out main harness.
 
Back
Top Bottom