rth hub on spindle force?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 29, 2009
Threads
102
Messages
496
Location
Rio Rancho, NM
Is there a trick to getting hub assembly on spindle shoulder? Seems like it's not wanting to go on any further or off and still have quite a gap. I'm afraid to damage the seal if I hit it it with hammer or slam it on too hard. Am I just being to cautious?
Used plenty of grease and inner bearing is seated properly in its spot.
 
Somebody grab a towel!
 
Back
Top Bottom