RTH - Front Diff leak

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 6, 2006
Threads
16
Messages
49
Got back from fishing today and noticed a big puddle of oil in the driveway. Tracked it down to the front diff seal. Looks like the paper gasket has started working its way out of the seal. I re-torqued the studs based on previous searches but given that the gasket looks toast it's gonna have to get fixed.

Any issues with re-filling the diff and driving it down to the mechanic tomorrow?

What sort of damage may have been done if it was driven around without any oil in there?

Thanks in advance.

John
 
Take the fillplug out and stick your finger in, see how low it is. You'd know by now if it was run dry, they don't last very long in this condition. The spiders sieze to the carrier, it gets really hot, stinks, etc.
 
Oil level was too low to touch with my finger so I started topping it off and it was pretty darn low.
 
If you had a puddle of oil in the drive, then likely it was not run dry. If the gears are even wet at their contact faces you're probably fine. If they're dry things get ugly fast - whining and howling. You had enough oil to make a puddle AFTER you parked, so a good thing. Also, check your diff vent - may be plugged - and now's the time to service it.
 
Make sure you have your mechanic use a oem toyota gasket. The PO of my truck had the front diff rebuilt and the mechanic used rtv to seal it back up, what a nightmare, let me tell you. It leaked like a sive. I am finsishing up a front rebuild, had to pull both axles out and unbolt diff clean all the rtv out put new gasket on and bolt back up and finish rebuild what a pain. But in the end there will be no more leak. So insist on using the oem gasket. Also I believe the front diff takes 3 qt so if you remember how much you had to add to fill it back up you can use the 3qt as a base number. I hear if you are a qt low things can get bad real quick.
 
Thanks guys. So I checked it again this morning and it definitely has a pretty good leak just sitting.

Given that the front diff is probably okay still, should I take the extra precaution and get it towed to the mechanic?

Thanks,
John
 
You'd need to have it flat bed towed.

If it were my truck, I'd just fill it and drive it.
 
Flat-bed tow truck or disconnect the rear or front drive shaft. I would recommend taking off one of the drive shafts and calling a regular tow truck if you are extremely worried. Mostly, I would just fill it up real good, and drive to a close shop.
 
Was able to top it off and get it down to my mechanic with no issues. Thanks for the wisdom and suggestions. :beer:

jmb
 
I'd just fill and drive it. Pull the rubber vent tube off the left top of the housing though, as even the slight pressure build up of a normally warming full diff will cause oil to leak MUCH faster. Unless you're heading off far away or on a fast road I'd just fill it and drive, stopping every couple miles to assess what's going on - even leave the fill plug finger tight so I could quickly check. Then I'd take a tenth of what I would have paid for a flatbed tow and buy myself a great lunch with the buddy who's coming to drive me home....

DougM
 
Make sure you have your mechanic use a oem toyota gasket. The PO of my truck had the front diff rebuilt and the mechanic used rtv to seal it back up, what a nightmare, let me tell you. It leaked like a sive. I am finsishing up a front rebuild, had to pull both axles out and unbolt diff clean all the rtv out put new gasket on and bolt back up and finish rebuild what a pain. But in the end there will be no more leak. So insist on using the oem gasket. Also I believe the front diff takes 3 qt so if you remember how much you had to add to fill it back up you can use the 3qt as a base number. I hear if you are a qt low things can get bad real quick.

If properly done, RTV only wont leak. It is more difficult to remove the diff next time. Most of the rock crawler types around here run RTV, it's believed to be a stronger setup vs the relative cushion of the gasket.
 
If properly done, RTV only wont leak. It is more difficult to remove the diff next time. Most of the rock crawler types around here run RTV, it's believed to be a stronger setup vs the relative cushion of the gasket.
Im was just speaking from my own recent experience, maybe they didnt properly seal my front diff with RTV. They used the red type and it leaked bad, bad enough to make me take the axles out and drop the front diff and clean it up and put and oem gasket on. I just didnt want another mudder to have to go through what I did.
 
Back
Top Bottom