RTH Engine problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 19, 2009
Threads
8
Messages
209
Location
Ft. Collins, Colorado
So I was cleaning my engine a bit. (famous last words, I know.) Rinsed everything off, At first it had a really rough Idle. I pulled the distributor cap, dried it out, cleaned the contacts and now it idles smooth. But it's acting like it has a 2000 rpm redline. Also while it is at idle the rpm slowly drops until it dies. When driving it has good power until 2000 then acts like it's hit a rev limiter. Idle air control valve and throttle position sensor plugs are dry. Any ideas?
 
Last edited:
Check your Coil wire. When you took the cap off, did you check that all connections are dry (btwn Cap +wrie+plugs)?
 
So I let the truck sit overnight and the problem didn't resolve itself. It basically acts like it redlines at just over 2k rpm. If I let it go that high it cuts out completely and the rpm drops to 1500 or so. It is also idles low. Any Ideas? I have a spare engine with all the electronics on it, so just tell me what to swap.
 
X2 on the coil or dizzy cap, also check and see if you got water past the spark plug boots.

If you get water down there the water will cause the spark to not get all the way to the plug, if that makes sense, not a very good explanation.

Also may sound dumb, but have your alternator tested, if it's not putting out full power, there may not be enough power to spark past 2000 RPMs (it has happened to me in the past).

Good luck man and post up what your findings are incase we have similar issues.

Shane
 
I had the same issue when I washed my engine bay for the first (and last) time- it would hit a wall at 2000 rpm no matter what gear I was in. I think the TPS got wet- I unplugged it over night to help it dry and it was fine the next day. This was after it had already sat for 1 day after the washing.
 
I had the same issue when I washed my engine bay for the first (and last) time- it would hit a wall at 2000 rpm no matter what gear I was in. I think the TPS got wet- I unplugged it over night to help it dry and it was fine the next day. This was after it had already sat for 1 day after the washing.

You sir are a gentleman and a saint. After cleaning and drying the distributer, changing the spark plugs, testing the VAF, testing the coolant temperature sensor, testing the fuel relay and resistor... I pulled the TPS, put my heat gun on it for a couple minutes and the problem is gone.
Thanks!
 
I hate to drag up an old post, but I'm having this exact problem. When you say you 'pulled the TPS', do you mean the electrical connection, or ... what?
 
Pull the electrical connector off the TPS and make sure all is dry. When I had the same issue I disconnected the battery to reset everything and it also solved the problem.
 
Thank you for the reply. I'll pull the electrical connector and disconnect the battery tonight and let it sit in the garage. Really appreciate the fast response.
 
IMG_8126.webp


and she runs perfectly again. lesson learned, don't wash the engine.
 
When washing an engine use low pressure water to wash it. I prefer to use a garden hose vs going to a car wash and doing it there.
 
Back
Top Bottom